xbox 360 wireless controller with wireless adapter for pc

Connect the USB wires to a host computer, and the data and serial wires to Arduino. RF module must be powered with 3.3V, two diodes in series with USB 5v will do. Original work by (yaywoop) / additional ideas from Alexander Martinez - modified by dilandou (First sends LED initialisation code followed by LED startup animation code, then sleeps until a button press for sync command.

* Arduino code to communicate with xbox 360 RF module. Wire - i have bolth some 22 AWG wire from radioshack and some fancy 30 AWG Kynar wire (easily avalible on ebay) pretty much any wire will work as long as it is small enough to solder to the connectons on the RF shield pliers - for holding small things/ bending wire. now that we've gotten that out of the way Parts List: Arduino UNO - a wonderfull microcontroller board you can get it on ebay or at radioshack RF Module - from a broken xbox/ ebay Soldering Iron - mine is a cheap radio shack model Solder - also avalible at a local radio shack USB cable - scavenged from old electronics (i found it in my parts bin) 2 1N4001 diodes Wire cutters - for cutting wire. ******DISCLAIMER******* DONT TRY THIS IF YOU DONT HAVE ANY EXPERIENCE WITH ELECTRONICS/SOLDERING OR COMPUTERS IM NOT RESPONSIBLE IF YOU SCREW UP. This instructable will go over the steps to connect a RF module from an RROD xbox to your computer so you can use a wireless controller with your computer.

Xbox 360 wireless controller with wireless adapter for pc